Design Layer Types in the Standards

The Layermap worksheet contains a specialized set of identifiers which control how model design layers are configured for a project file. These identifiers, which are located on the extreme right of the Layermap worksheet opposite the model layers, are used by the Setup commands to correctly configure a set of model layers for the project file.

Model layer type identifiers can take on one of the following values:

 

Identifier	Meaning
C	Layer w/ ceiling referenced information (one per floor)
F	Foundation layer (one per project)
R	Roof layer (one per project)
S	Slab layer (one per floor)
W	Layer w/ floor referenced information (one per floor)
<no value>	Supplemental model layer